Setting Up Your Monitor - Angelcare AC 201 Manuel De L'utilisateur

Setting Up Your Monitor

SENSOR PAD (See figs. 1 and 2)
Place the Sensor Pad under the center of the crib mattress with the blue side facing up. Do not place
any loose bedding or linen between the crib mattress and the Sensor Pad. The Sensor Pad must rest
on a flat, firm surface. If your crib has a spring or slat base, place a piece of Masonite board under the
Sensor Pad. This support must measure at least 13 inches long on all four sides and 1/4 inch thick. If
your crib has a plywood base, your mattress support is firm enough to use the monitor properly. Only
use your Angelcare® monitor in a stationary sleeping environment such as a crib where the Sensor
Pad can rest on a flat, firm surface. Be sure to place the turquoise side of the Sensor Pad facing up.
CAUTION: To avoid potential strangulation accidents resulting from loose cords or wires in the crib,
make sure the Sensor Pad cord passes underneath the mattress entirely. After positioning the Sensor
Pad under the mattress, bring the cord to the corner of the crib and secure it to the top and bottom of
the leg of the crib, or wind it around the leg (see fig. 1).
Figure 1
PLACEMENT OF SENSOR PAD CORD
CORRECT
Sensor Pad
Figure 2
POSITION OF SENSOR PAD UNDER MATTRESS
CORRECT
Sensor Pad Centered Blue Side Up
Movement Sensitivity Control
IMPORTANT: Only use the AC adapters included with your monitor. Do not use these
adapters with any other equipment. Movement Sensitivity Control. The movement sensi-
tivity control is on the back of the Nursery Unit. The level has been preset to suit most con-
ditions of movement detection (see fig.3). Do not adjust this unless you receive false
Figure 3
alarms. Refer to the Movement Sensitivity Adjustment section on Pg. 12 for more informa-
tion. It is extremely important to follow our instructions for setting the sensitivity level.
Now plug the Sensor Pad cord into the jack on the back of the Nursery Unit marked
"Sensor Pad." Turn the Nursery Unit on using the switch on the left. The green Power
Indicator will light up.
(Top Down View of Crib)
INCORRECT
Sensor Pad O Center
9
INCORRECT
Sensor Pad
INCORRECT
Sensor Pad Blue Side Down