Configuration - thuba PS 830 Manuel

Manual BVS 19 ATEX E 080 X
Press key
The bypass code is needed
The ex works Bypass code is
'0002'. If the code has been
changed you will have to enter
the amended code.
Enter is right code using the
arrow keys
and confirm with the ENTER-key.
The bypass mode is now active.
The bypass will be deactivated in
the same way.
The origin state is normal operation, the Ex p
housing can be purged, un-purged or while purg-
ing.
5.6

Configuration

You must configure and enter the parameters of
the control unit FS840 to achieve a desired
mode of operation.
All parameters of the control unit are structured
in form of a menu.
The Master Code (M-Code) ex works is: 0001
5.6.1 The menu format
In the table in Appendix C2 below shows expla-
nations of the menu items. The table works as a
reference guide for programming the desired
system structure and to set the appropriate
parameters correctly. The menu items are rough-
ly sorted by class.
Edition July 2020
Copyright
按键
需要旁路编码
出厂旁路编码是0002，如果编码更
改了，需要输入更新的编码。
按键使用箭头键输入编码
按ENTER健确认
旁路编码已经激活
旁路将以同样的方式停用。
初始状态是正常运行的，正压防爆腔体可以被吹
扫过的、不吹扫或正在吹扫。
5.6 配置
您必须配置并输入控制单元FS840的参数以实
现所需的操作模式。
控制单元的所有参数都是以菜单的形式构造的。
出厂主代码(M-码)是：0001
5.6.1 菜单格式
在附录D2中的表格中显示了菜单项目的注解。
该表作为编程所需系统结构和正确设置适当参数
的参考指南。 菜单项按类进行粗略排序。
35
thuba Ltd., CH-4002 Basel
Switzerland