Satcr Mode - Alcad 918 Serie Manuel D'utilisation

In this example, the position is 2 (1 to 127 pre-loaded positions in the positioner)
If the positioner is on No, it is deactivated
See chapter Man-machine interface

14.2.4 SatCR mode

Description:
SatCR: Satellite Channel Router or Single Cable Distribution
Distribution of the satellite signal with only one coaxial cable in single-family dwelling to 2, 4 or 8 different
receptors.
To give several receptors access to the whole spectrum and all polarizations, you need one coaxial cable
per receptor and a suitable installation (multiple LNB, Quattro and multi-commuters).
The SatCR mode is an extension of the DiSEqC protocol that allows the connection of several receptors on
only one coaxial cable, no matter the band (H/L) and the polarization (H/V).
A European industrial standard has been developed for delivering satellite signals on only one coaxial
cable - EN50494.
Functioning:
Each satellite receptor uses a fix frequency band (Slot or Port), whose width is (more or less) equal to the
width of the transponder.
The receptor requires a specific transponder frequency (frequency Ku) via a DiSEqC command.
Some equipment on the satellite dish (LNB or switch SatCR) moves the requested signal to the center of the
selected band (Slot). Then, the mixing equipment adds each user band (Slot) to only one output (up to 8
user bands).
The SatCR mode has priority on all other modes: selection polarization, selection OL, switches
committed and uncommitted and positioner.
68
for any change.