Modification Of Parameters - Alcad 918 Serie Manuel D'utilisation

11.2 Modification of parameters

You can either do measures on a saved setup in the current list (see chapter «
Measurement Lists »), or modify manually each parameter.
The various parameters are:
•
The name of the setup (selection on the active list)
•
The frequency of the emitter or transponder (and the true frequency of satellite)
•
The standard and bandwidth for DVB-T/H and DVB-T2
•
The corresponding channel number for terrestrial and cable mode
•
The symbol rate for the satellite
•
The polarization and the band for the satellite
•
The audio mode for the analogical TV
The + key in the lower right corner displays (under DVB-T/H, DVB-T2, DVB-S and DVB-S2) the following
information:
•
The spectral inversion of the signal
•
The frequency offset
•
The Viterbi rate of the HP flow
•
The Viterbi rate of the LP flow
•
The level of the hierarchical mode
•
The cell identification
See chapter Man-machine interface
49
to make any change.
Setting the parameters of the