Checking A Terrestrial Antenna - Alcad 918 Serie Manuel D'utilisation

2.2.1 Checking a terrestrial antenna

In this case, the Autoset function allows a scan of the channels that the antenna detects.
Plug the cable of your antenna to the FSM-640 (take care to use an adequate adaptor)
Turn your appliance on. Press the Home key
The Home page appears on screen. Press Autoset
On this page, press Mode, Terrestrial, then select DVB-T and 8MHz (as here below)
The scan should range from the E2 to the E69 channels, frequency range Europe (you may reduce the
number of channels to scan if you know the range of the emitter where the antenna points at: the scan will
be faster)
Press START. The appliance searches until the end of the scan and turns directly to the Measurement plan
mode. If channels were found, the appliance makes measurements continuously (C/N-level, then
BER/MER) on the detected channels. If no channel has been found, see the next chapter.
10