Check Sat Function - Alcad 918 Serie Manuel D'utilisation

Mesureur de champ
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9.2

Check Sat function

Procedure:
1/ Connect the satellite dish to the appliance and start it up.
2/ Validate the remote power supply:
VDC lights up.
-
Check the power supply current of the LNB (IDC at the top right corner of the screen should be
-
between ca. 50 and 200 mA).
See chapter
3/ On the Home page, go to the Check Sat mode.
Select the satellite to aim at in the list (example ASTRA1)
4/ Slowly orientate the satellite dish until hearing the locking melody and getting the best quality.
5/ Slightly turn the LNB to get the best quality (counter-polarization).
You will hear a melody as soon as a first transponder is detected; then, you will hear beeps. These
beeps are closer and closer as the quality increases.
41
Remote power supply / LNB – DiSEqC

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fsm-6409180008

Table des Matières