Alcad 918 Serie Manuel D'utilisation page 124

Reminder: transponder = satellite channel
To check if the aimed satellite is the right one: press the NIT key
The appliance searches the MPEG NIT table on one of the 4 transponders and displays the name of the
satellite:
Attention: The displayed name depends on the content of the MPEG NIT table.
Some distributors provide no (or poor) such table.
The displayed information may be wrong.
Attention:
To identify a satellite, you must be « hooked » on all 4 transponders. (Quality > 0)
However, some transponders are regularly modified. See the frequency range of the
satellite when a transponder does not seem to work.
Some switches or LNB work only with DiSEqC commands. In this case, position the band
(OL) and the polarization on DiSEqC at the Configuration page LNB-DiSEqC.
(Attention: the Check Sat is slower when using the DISEqC command).
15
No found transponder • red smiley
Average reception quality (< 50%) • orange smiley
Good reception quality (> 50%) • green smiley