Alcad 918 Serie Manuel D'utilisation page 135

ZDF SatCR slot 3...
If a parameter of a setup changes, for example a modification of rate or change from DVB-S to DVB-S2,
only the setup inside the library should be updated.
These lists and setups may be created on a computer thanks to a spreadsheet and loaded to
the appliance through a USB stick.
A list of measurements is made of:
•
a list name in 10 characters
•
the lowest frequency of the LNB (OL1)
•
the highest frequency of the LNB (OL2)
•
the selection mode low band / high band of the LNB
•
the selection mode of the polarization
•
the presence of the position number of the positioner (motorized satellite dish)
•
50 lines including each:
•
a setup number corresponding to the setup list
•
the presence and the functioning mode of the switch, committed type
•
the position of the switch, committed type
•
the presence and the functioning mode of the switch, uncommitted type
•
the position of the switch, uncommitted type
•
the presence of SatCR equipment
•
the SatCR slot number
•
the position of the SatCR switch
A few of these parameters are specific to the waveband of the satellite and have no influence in terrestrial
and cable modes.
Presentation of a measurement list in a spreadsheet:
A setup is made of:
•
a setup name in 8 characters
26