Disassembly And Reassembly - MSA Super V Helmet Instructions D'utilisation

Masquer les pouces Voir aussi pour Super V Helmet:

Mode d'emploi (20 pages)

Table des Matières

Les langues disponibles

NOTE: When replacing the suspension, the liner must be removed from the shell, and the surfaces of the

shell and liner that are not normally visible should be inspected for the above conditions. (See 5 "Disas-

sembly and reassembly" and 4.1 "Useful service life guidelines").

Helmet care

Helmets must be cleaned regularly for easy inspection and to help the wearer avoid skin irritations. Clean

only with mild soap (no detergents) and warm water.

Like any piece of specialized equipment, a helmet must not be abused. It must not be thrown, dropped or

used as a support.

The helmet must be stored in a clean, dry area not subject to extremes of heat, cold, or humidity.

4.1

Useful service life guidelines

The Super V Helmet was designed with high quality, wear resistant materials; but it will not last forever. The

protective properties of the helmet will be degraded by exposure to many common work environments, such

as temperature extremes, chemical exposure, UV radiation, and normal day-to-day wear and tear.

The user must inspect the helmet regularly (see 3 "Inspection") and replace it or any part necessary. Never

take a chance with your safety. In extreme exposure conditions, the helmet (or certain parts) may need to

be replaced even after only a short period of use. As a general guideline, even if the helmet appears to be

in good shape, MSA recommends the following replacement schedule.

Part

Suspension

Entire helmet

Tab. 1

Replacement schedule

Remember that these are maximum useful service life guidelines. Wear or damage noticed during a regular

inspection must be the determining factor for possible earlier replacement. In any case, always replace the

helmet after it has withstood impact or penetration.