upper lines) has to be checked under 5Kgs of tension. The differ-
ence between the measured length and the original length should
not exceed +/- 10mm.
The changes that could appear are a slight shrink on the C or Ds
and/or a slight stretch on the A, B. The consequences of these
changes can include a slower trim speed, difficult inflation etc.
Full check - A full visual check should be carried out: All the
components of the wing (stitching, ribs, diagonals, lines, tabs, ...)
should be checked for signs of detoriation.
Finally, a flight test that confirms that the wing behaves normally
should be carried out by the professional.
IMPORTANT: Take care of your glider and make sure you
have it checked according to the above schedule: This will
ensure you hours of safe flying.
MODIFICATIONS
Your Ozone Speedster was designed and trimmed to give the opti-
mum balance of performance, handling and safety. Any modifica-
tion means the glider loses its certification and will also probably
be more difficult to fly. For these reasons, DO NOT modify your
Speedster in any way.
OZONE QUALITY & SERVICE
At Ozone we take the quality of our products very seriously, all our
gliders are made to the highest standards in our own manufactur-
ing facility. Every glider manufactured goes through a stringent
series of quality control procedures and all the components used
to build your glider are traceable. We always welcome customer
feedback and are committed to customer service. We will always
undertake to fix problems not caused by general wear and tear or
inappropriate use. If you have a problem with your glider please
contact your dealer/distributor who will be able to decide upon the
most appropriate action. If you are unable to contact your dealer
then you can contact us directly at info@flyozone.com
Ozone Guarantee
Ozone guarantees all of its products against manufacturer's defects
or faults. Ozone will repair or replace any defective product free of
charge.
Ozone and its distributors provide the highest quality service and
repair, and damage to products due to wear and tear will be re-
paired at a reasonable charge.
17