Assembly And Adjustments; Throttle Cable - Shindaiwa HT2510 Manuel D'utilisation

Assembly and Adjustments

Throttle Cable

Connect the Throttle Cable
1. Loosen the air cleaner cover knob
and remove the air cleaner cover.
See Figure 11.
2. Slip the throttle cable into the cable
adjuster and hook the bullet end of the
cable onto the swivel. See Figure 12.
Connect the Ignition Leads
3. Connect the ignition wires by pushing
the bullet connectors together. See
Figure 13.
4. Reinstall the air cleaner cover.
CAUTION!
Routing of wiring must not interfere
with throttle or choke operation.
Assembly and Adjustments
Throttle Cable Free Play
If the unit does not return to idle speed or
doesen't reach full rpm, the throttle lever
free play may need to be adjusted as follows:
1. Measure free play at the end of the
throttle lever. Throttle lever free play
should be approximately 0.2-0.275"
(5-7 mm). See Figure 14.
2. If adjustment is necessary, remove the
air cleaner cover. Loosen the cable ad-
juster lock nut and turn the cable adjust-
ment fitting in or out until throttle lever
free play is approximately 0.2-0.275" (5-7
mm).
3. Replace the air cleaner cover, and tight-
en the cover retaining screw securely.
8
Air Cleaner
Cover
Knob
Figure 11
Ignition
Lead
Figure 13
0.2-0.275"
(5-7mm)
Throttle Lever
Free Play
0.2-0.275"
(5-7mm)
Figure 14
Connect
the
Throttle
Cable
Throttle
Cable
Cable
Adjuster
Figure 12
Ignition
Lead
Throttle
Cable
Adjuster
Lock Nut
Throttle
Cable
Adjuster
Throttle
Cable
Figure 15
Cable
Swivel