Shindaiwa HT2510 Manuel D'utilisation page 7

Assembly DH2510
(1) Attaching the Rear Handle
to the Gearcase Assembly
WARNING!
Collar
Incorrect as-
sembly could
expose the
Rear
operator to
Handle
serious injury!
Read and fol-
low assembly
instructions
Cushion
carefully. Be-
fore attaching the rear handle,
make sure the rear handle
cushions are located correctly.
1. Slide the rear handle onto the rear
flange of the cutter/gearcase assem-
bly. Make sure the throttle cable and
ignition and ground wires do not bind
during assembly.
2. Make sure the mating holes between
the rear handle and the gearcase are
aligned, then secure the rear handle us-
ing two 6 mm x 35 mm socket head cap
screws and washers.
Viewed from
the bottom
Throttle Cable,
Ignition and Ground
Wires
Figure 8
IMPORTANT!
The washers used on the front handle and the
rear handle are not the same. The washers for
the rear handle are black for identification.
Rear Handle
Assembly
Figure 10
(2) Install the Front Handle
1. Locate the front handle onto the cutter/
gearcase assembly as shown.
2. Secure the handle using two 6 mm x
30 mm socket head cap screws and
Cushion
washers.
(3) Installing the Powerhead
on the Gearcase
 Orient the gearcase assembly and
powerhead as shown and secure with the
three 6 mm x 16 mm screws (A, B, and C).
1. Securely tighten screws A and B.
2. Push screw C through the eye termi-
nal in the throttle control ground wire
(black), and then install and firmly
tighten the screw to the powerhead.
Figure 9
Cutter/Gearcase
Powerhead
Assembly
6 mm x 35 mm
Socket Head Cap screws
and Washers (washers
black for identification)
Front Handle
6 mm x 30 mm socket
head cap screws and washers
Figure 7
Screw C
(6 x 16 mm)
Screws A and B
(6 x 16 mm)
7