Table des Matières
Publicité
Technical description
(see illustration page 41)
1. Wire feed speed control
2. Adjustment of welding voltage during MIG and
welding current during MMA (certain types only)
3. Selector switch for 2-times/4-times/spot welding
functions and for certain types: MMA-welding
4. Volt/Ammeter (certain types only)
5. Soft start ON/OFF and soft start function control.
By adjustment to max. value the soft start is
automatically disconnected. The MWF returns to
set value.
6. Spot welding timer (the spot welding time is
measured from the time when the arc is started)
7. Burn-back control
8. Gas post-flow timer
9. Wire-inching control
10. Connection of torch
11. Plug for connection of remote control/push-pull-
control cable (extra equipment)
12. Torch watercooling connection (certain types
only)
13. Control cable connection
14. Welding cable connection
15. Shielding gas connection
16. Fuse 10 A (except MWF 8 and 10)
17. Craterfilling
18. Programme selector
1-8 Are not to be found on MWF 15 and 25
Accessories
(see illustration page 42)
1. Connection panel with fitted intermediary cable
(MWF 8 and 10)
2. Connection panel with plug for intermediary cable
(MWF 11 and 15)
3a. Control panel without volt/ammeter (only MWF 8,
10, 11 and 21)
3b. Control panel with volt/ammeter (only MWF 8, 10,
11 and 21)
3c. Control panel with volt/ammeter and voltage ad-
justment (only MWF 8, 10, 11 and 21)
4. Protection kit
5. Wheel kit
6. Suspension kit
7. Relief arm
8. Intermediary cable
9. Push-pull kit
10. Arc-detector kit
11. Kit water cooling (MWF 11)
12. Kit, sliding blocks
13. Wire cassette
14. Sledge, black
14. Sledge, galvanized
15. Wire reel holder
16. Synergic kit (only control panel 3c)
17. Kit for connection of MMA-welding cable
WARRANTY REGULATIONS
All MIGATRONIC machines carry a twelve month
guarantee against hidden defects. Such defects must
be notified no later than two months after it has been
noticed. The warranty runs for twelve months after
invoicing to end customer.
The warranty becomes void by faults that can be
attributed to incorrect installation, pests, transport
damage, water- and fire damage, strokes of
lightning, use in connection with a synchronous
generator and use under abnormal conditions, which
lies beyond the product specification.
Lack of maintenance
There is a lapse of warranty if the product is not
properly maintained e.g. if the product is dirty to such
a degree that cooling is hindered. The warranty does
not cover damages which can be traced back to
unauthorised and incorrect repairs of the product.
Wear parts
The warranty does not cover wear parts (welding
hoses, welding cables and wire drive rolls)
Resulting damages
Use of the product must stop immediately after
acknowledgement of a defect in order to avoid
further damage of the product. The warranty does
not cover resulting damages due to use of the
product after acknowledgement of a defect. More-
over, the warranty does not cover resulting damages
on other items due to product defect.
11
Publicité
Table des Matières
