Fitting The Harness - Stihl FSB-KM Notice D'emploi

English
STIHL PolyCut 5 - 3
8
7
3
Insert the nut (8) in the mowing
N
head.
Screw the mowing head (7)
N
clockwise on to the shaft (3) as far
as stop.
Block the shaft.
N
Tighten down the mowing head
N
firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
12
Remove the mowing head.
STIHL AutoCut 11 - 2
Unscrew the cap counterclockwise
N
from the shaft.
STIHL PolyCut 5 - 3
Block the shaft.
N
Unscrew the mowing head
N
counterclockwise.

Fitting the Harness

The type and style of the harness,
carrying ring and carabiner (spring hook)
depend on the market.
The use of the harness is described in
the chapter on "Approved Combinations
of Cutting Attachment, Deflector, Handle
and Harness".
Shoulder strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
1
FSB-KM