Remote Control; Simplified Eu Declaration Of Conformity; Mounting The Wall Bracket; Initial Operation - clage DSX Touch Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DSX TOUCH

3. Remote control

EN
Figure A:
Installation with adhesive tape
Figure B:
Optional installation with dowels and screws

Simplified EU Declaration of Conformity

CLAGE GmbH hereby declares that this device complies with Directive 2014/53/EU.
The complete text of the EU Declaration of Conformity is available at the following
internet address: www.clage.com/downloads.
Technical data
Model
Operating voltage
Type of battery
Type of protection
Transmission range
Transmission power
Transmission and receiving
frequency range
Radiation
Approvals
1) Do not use rechargeable batteries.

Mounting the wall bracket

• Before attaching the wall bracket to the wall, ensure that the remote control
has radio contact to the instantaneous water heater from its designated posi-
tion.
• The wall bracket of the remote control can either be attached securely with the
included adhesive tape, after stripping off the protection film (as shown in the fig-
ure A), on a rigid board (e.g. tile) or with suitable dowels (Ø 4 mm) and screws (as
shown in the figure B).
• When using the adhesive tape it is not possible to further adjust the position
because of the strong adherence of the glue. Therefore, pay attention to a horizontal
alignment when attaching it.
• The remote control is magnetically retained at the wall bracket.
• Keep the remote control and wall bracket away from credit cards or other cards
with magnetic strips. The built in magnets can damage the card's magnetic
strip.

Initial operation

After inserting the batteries in the remote control its display indicates all symbols for
about 4 seconds. By the time the power settings have been carried out, the remote
control indicates the current setpoint (factory setting 38 °C) and the state of the appli-
ance. In case of a failing radio contact, the display indicates "
ing radio symbol (see Troubleshooting).

Registration of remote control at the instant water heater

The remote control is registered as-delivered condition.
Only register again after performed work reset at the DSX Touch or when the remote
control display continually indicates "
1. Make sure that the power supply to the instantaneous water heater is switched on
(fuse).
2. Remove the batteries until the display expires. After inserting the batteries, the
24
FX Remote control
3 V
2x AAA Alkaline
1)
IP 20
10 metres incl. barrier
< 10 mW
868.0 – 868.6 MHz
undirected
Europe EN 300 220 / CE
no
" and a cyclical, flash-
no
".

Publicité

Table des Matières
loading

Table des Matières