Weighing Below The Balance - Mettler Toledo PE200 Mode D'emploi

ADDITIONAL FEATURES OF PE BALANCES: Restless weighing objects; weighing below the balance
All PE balances are shipped with the DeltaDisplay switched on. In case of rapid weight changes, the display changes are automatically increased and the last digit
is temporarily blanked out. The DeltaDisplay can be switched off by an internal switch. In addition, the integration time can be doubled. In this case, display changes
are only half as fast. This makes it possible to adapt PE balances to difficult conditions and to stabilize restless displays to the correct value.
All PE balances are equipped for weighing below the balance.
Switching DeltaDisplay and integration time
If restless objects have to be weighed (e.g., live
animals) or if weighing must be made under
conditions of external instability (i.e., drafts), the
result can be stabilized by switching of DeltaDisplay
and doubling the integration time.
This procedure can also be handled by METTLER
TOLEDO Service.
– Disconnect power cable.
– Open balance housing (see page 4,
"PREPARATION; How to check the voltage
setting").
Switches (20) (21) for DeltaDisplay and integration
time are located directly behind the display.
Slide switch (20) at left controls DeltaDisplay and
stability detector.
– DeltaDisplay and SD on: Switch is at the stop
nearer to the display.
– DeltaDisplay and SD off:
Switch is at rear stop.
Slide switch (21) at right is used to adjust the
integration time:
– Short integration time: Switch is at the stop
nearer to the display.
– Long integration time:
Switch is at rear stop.
– Close balance housing (see under
"PREPARATION: How to check the voltage
setting").

Weighing below the balance

Your PE balance is specially equipped to handle
weight determinations that can not be made on the
weighing pan. This is done by suspending the object
from the weighing cell. To do this, the balance table
must have an appropriate opening.
– Remove weighing pan and pan support, and
tilt balance to its side.
– Remove cover (23).
– Using a holder, suspend weighing object from
hook (24).
– Set balance right side up and install weighing
pan and pan support.
– With holder attached, tare balance.
11