How To Weigh In With Deltadisplay - Mettler Toledo PE200 Mode D'emploi

OPERATION: How to weigh in
Weighing-in means to fill loose or liquid objects into a container on the pan until a desired weight (target weight) is reached.
All PE balances are equipped with DeltaDisplay which considerably simplifies weighing in. To help you follow the weight changes, the display sequence speeds up
automatically and the last decimal place of the display is blanked out. A stability detector is switched on along with the DeltaDisplay and it blocks the data output until
the weighing result is stable enough. DeltaDisplay and stability detector can be switched off from within the balance (see also "ADDITIONAL FEATURES OF PE
BALANCES").
Weighing-in
– Place container on pan.
– Tare (15): Balance will now indicate zero.
– Fill in weighing objects until desired target
weight is reached.
Reading the result
While filling in at a steady and fairly rapid pace until
you reach the vicinity of the target weight, watch only
the first two digits (16).
During fine weighing-in to the actual target weight,
watch primarily the digits at right (17).
When the weight increases rapidly, there is also an
automatic increase in the display speed and the last
digit (18) is temporarily blanked out. It reappears
again when fine weighing-in is resumed.
Weighing-in several components
If different objects are to be weighed in one after the
other, the operator can tare after each component.
This way, every new weighing can start from zero.
This procedure can be continued until the combined
weight of the container and of the weighing objects
reaches the end of the total weighing range of the
balance:
– PE200 210 g
– PE400 410 g
– PE2000 2100 g
– PE4000 4100 g
9