Integrated Decalcifying Program - Melitta SOLO Mode D'emploi

Integrated decalcifying program

the integrated decalcifying program removes lime scale in the interior of the appli-
ance. It takes a total of approximately 25 minutes. the symbol for decalcifying
flashes during the entire process.
Prerequisite: The appliance is switched off. Remove the Melitta Claris
water filter - if present - from the water reservoir (see page ).
Caution!
–
execute the integrated decalcifying program every 3 months or when
the symbol for decalcifying
– Only use the decalcifying agent from Melitta
makers. this decalcifying agent is precisely matched to the Melitta
sOLO.
– Never use vinegar or other decalcifying agents.
execute the integrated decalcifying program as follows:
1 simultaneously press the button for two-cup dispensing
On / Off button
→ the symbol for decalcifying
illuminated.
2 empty the drip tray and then reinsert it.
→ the symbol for the water reservoir
3 Flip up the lid of the water reservoir (Fig. A, no. ) and pull the water
reservoir up and out of the appliance.
4 Pour the descaler powder into a separate bowl filled with 0.5 l of hot
water. stir in the descaler powder (e.g. with a long spoon). As soon as the
descaler powder is completely dissolved, pour the descaler solution into
the water tank.
5 Re-insert the water tank.

Heft_Solo_EU.indd 64
is illuminated in the display.
for more than 2 seconds.
flashes and the symbol for the drip tray
is illuminated.
for automatic coffee-
®
®
and the
09.07.2009 15:47:43
®
is