Briteq BT-NODE28 Mode D'emploi page 9

ENGLISH
[Port Status: Input / Output / Disabled]
Defines the status of the DMX-port: input signal, output signal or disabled
[Port Mode]
If [PORT STATUS] = [INPUT]: [Port Mode] can be set to:

NORMAL: the DMX Port receives the DMX-signal and sends it to the 1st selected ArtNet universe in
the ["Main Universe"] section.

BACKUP: the DMX Port receives the DMX-signal and sends it to the 1st selected ArtNet universe in
["Main Universe"]. In case of failure, or when there are no DMX values on the 1st selected ArtNet
universe for more than 3 seconds, the BT-NODE28 automatically starts sending the DMX values
from the backup port.
If [PORT STATUS] = [OUTPUT]: [Port Mode] can be set to:

SINGLE: the DMX-signal is sent to the DMX Port from the 1st selected ArtNet universe in ["Main
Universe"].

HTP: The DMX-signal is sent to the DMX Port from the merging of the 1st and the 2nd selected
ArtNet universe in ["Main Universe"]. The BT-
NODE28 compares the values on the inputs
and sends the highest value to the DMX Port
for each DMX channel in both universes.

LTP: The DMX-signal is sent to the DMX Port
from the merging of the 1st and the 2nd
selected ArtNet universe in ["Main Universe"].
The BT-NODE28 compares the values on the
inputs and sends the last changed value to the DMX Port for each DMX channel in both universes.

RDM: The output of the DMX-Port is now RDM capable.

ZERO: The BT-NODE28 sends "0" to all channels
[Frame rate]
When the port status is set to [output] you can define the number of DMX frames sent per second.
The default setting is: 40 frames/second. But you can als select: 10,15,20,25,30 or 35 fr/second.
[Universe]
Press [ENTER] to open a new menu and select the first and the second universe dedicated to this port.
Important note: the second universe is only use when the port status is output and HTP/LTP mode.
[Resend]
Select [Resend] if you want to resend data from the
HTP/LTP merger to the ArtNet. This function only
works when Port Status is set to output and port mode
is HTP/LTP. Specify the ArtNet universe where you
want to send the merger results in Resend option.
BRITEQ
®
7/66
OPERATION MANUAL
BT-NODE28