Briteq BT-NODE28 Mode D'emploi page 5

ENGLISH OPERATION MANUAL
DESCRIPTION
FRONT PANEL
ON
POWER
LINK
MENU
ACTIVITY
OFF
ETHERNET NODE / DMX PROCESSOR
3 4
2
1
(1) 3 Leds: power on, link (network link up), activity (network activity)
(2) DISPLAY: shows all relevant information, "OLED" technology with large view angle and high brightness.
(3) 4 navigation buttons: [MENU], ▲/▼ and [ENTER]
(4) Power button: used to switch the unit on/off
REAR PANEL
POWER ETH IN ETH OUT DMX 1 DMX2 DMX3 DMX 4 DMX 5 DMX 6 DMX 7 DMX 8
5 6 7
(5) Power input: 100V – 240V IEC inlet with fuse holder
®
(6) 2x Neutrik RJ45 Ethercon : 10/100Mbps network connection for Art-Net.
(7) 8x XLR female connectors: XLR-3pin or XLR-5pin, depending on the version bought.
IMPORTANT NOTE
All XLR-connectors are female, which is the standard "DMX-output" connector. So
if you configure a DMX-port as a "DMX-input": don't forget to add an XLR
male/male-adapter. Adapters XLR-3pin male/male are separately available with
order code 1318. Adapter cables XLR-5pin male/male will be available soon.
ABOUT ART-NET
Art-Net is an Ethernet protocol based on the TCP/IP protocol suite. Its purpose is to allow transfer of large
amounts of DMX512 data over a wide area using standard networking technology.
Credits: Art-Net™ Designed by and Copyright Artistic Licence Holdings Ltd
BRITEQ 3/66 BT-NODE28
®