Briteq BT-NODE28 Mode D'emploi page 11

ENGLISH
 USER PRESETS: here you can make and save your personal presets. After saving you can use / edit
these presets at any time in the future.
To create, manage and apply your personel presets, use ▲/▼ to select [User Presets] and press
[ENTER] to confirm. In this section you have a list of 8 personal presets.
You can:
 EDIT an existing user preset
 LOAD an existing user preset
 SAVE the current settings to a user setting.
For each of your user preset you can:
 Rename: set the name of your preset in the user preset list
 Device Name: set the Device Name
 IP Address: set the IP Address
 Netmask: set the Netmask
 Device ID: set the device ID
 DMX Port: set the DMX-Port configuration (see [SET DMX PORT] for setails)
9. VERSION
Shows the firmware version of your BT-NODE28
MERGER MODE
To use the BT-NODE28 as a dmx merger we need two different sources. The signal can come from a DMX
input, an ArtNet input or both. You must configure an output to merge the signal of the two sources. The
output merging option can be LTP (Last Takes Precedence) or HTP (Highest Takes Precedence).
Input:
Internal: set 2 ports as input mode, each with a different 1
Port status
Port mode
Frame rate
Main Universe
Resend
Display mode
External: 2 different Artnet universes need to be received by the device to perfom the merging.
Output:
Set the selected port as "OUTPUT"
Port status
Port mode
Frame rate
Main Universe
Resend
Display mode
BRITEQ
®
st
universe
Port configuration
INPUT
Single
040
st
1 : choose an unique universe number (0 to 255)
for each splitter in the node.
nd
2 : no need to configure
disable
Dec
Port configuration
OUTPUT
HTP / LTP
040
st
1 : select the universe of one of the inputs
(local or ArtNet)
nd
2 : select the universe of the other input
(local or ArtNet)
disable
Dec
9/66
OPERATION MANUAL
BT-NODE28