Briteq BT-NODE28 Mode D'emploi page 10

ENGLISH
[Display mode]
with this option you can choose between two different display formats:

Hexadecimal (0.0 –> F.F)

Decimal (1->256)
Attention: Some Art-Net products use 0 to 255 for universe numbering, the BT-NODE28 numbers the
universes from 1 to 256. In such case you have to shift the universe one number: so 0 --> 1, ..., 255 -->256.
5.SET [ID NO]
The Device ID is a numerical identifer to easy recognize the device. You can check the ID-number from the
Status menu.
Set the device ID by pressing [MENU] and ▲/▼ to select [Set ID NO]. Press [ENTER] to set the device ID.
Use ▲/▼ to change the device ID you want from 0 to 255, press [ENTER] to confirm.
6. SET LED BACKLIGHT
Set the LCD Backlight by pressing [MENU] and ▲/▼ to select [Set LCD Backlight]. Press [ENTER] to set the
LCD Backlight. Use ▲/▼ to select:

ON: LCD is always lit.

OFF: LCD turns black after 30seconds (only the LEDs on the front panel are active)
Press [ENTER] to confirm.
7. SET LED BRIGHTNESS
Set the display brightness by pressing [MENU] and ▲/▼ to select [Set LED Brightness] followed by
[ENTER]. Use ▲/▼ to adapt the LED Brightness between 0 and 10, followed by [ENTER] to confirm.
8. PRESETS
The BT-NODE28 has 2 different kinds of presets:
 FACTORY PRESETS: these are common presets, often used by most of the people. Further in this
manual we give a detailed explanation of these factory presets. Note that not all parameters of the
factory presets are editable: the table shows which parameters can be edited and which cannot.
FACTORY PRESETS
[ 8DMX to Art-Net ]
[ Art-Net to 8DMX ]
[ DMX Split 1>7 ]
[ DMX Split 2x1>3 ]
[ Art-Net Clone ]
[ 8DMX to RJ45 ]
[ RJ45 to 8DMX ]
BRITEQ
®
NON EDITABLE PARAMETERS
Dmx ports configuration
Dmx ports configuration
Dmx ports configuration, IP, Netmask
Dmx ports configuration, IP, Netmask
Dmx ports configuration
Dmx ports configuration, IP, Netmask
Dmx ports configuration, IP, Netmask
8/66
OPERATION MANUAL
EDITABLE PARAMETERS
IP, Netmask, Frame rate, Display mode
IP, Netmask, Frame rate, Display mode
IP, Netmask, Frame rate, Display mode
BT-NODE28