Briteq BT-NODE28 Mode D'emploi page 13

ENGLISH
Configuring a personalized splitter
Set input and output for each port separately. No IP configuration or network cable needed for this
configuration.
Input port configuration:
Menu > Set DMX Port >Select your Port >
Port status
Port mode
Frame rate
Main Universe
Resend
Display mode
Output port configuration:
Menu > Set DMX Port >Select your Port > (different from the input port)
Port status
Port mode
Frame rate
Main Universe
Resend
Display mode
Note: It's possible to configure the splitter as you like, for example input port 7 and output port 1-2-3-4, ...
Just keep in mind that the 1
and different for other splitters that would be configured inside the same BT-NODE28.
ART-NET-NODE MODE
There are different ways to use the BT-NODE 28 as an ArtNet node, using factory presets:
8X input
In this mode, the BT-NODE28 converts 8 DMX512 inputs into 8 separate ArtNet universes and sends them
to the network through ETH OUT. A network configuration needs to be done according to your network and
your ArtNet receiver:
POWER
BRITEQ
®
Port configuration
INPUT
Single
040
st
1 : choose a unique universe number (0 to 255) for
each splitter in the node
nd
2 : no need to configure
disable
Dec
Port configuration
OUTPUT
Single
040
st
1 : choose the same unique universe number (0 to
255) as the associated input port
nd
2 : no need to configure
disable
Dec
st
universe number should be the same between the ports of the same splitter,
ETH IN ETH OUT DMX 1
11/66
OPERATION MANUAL
DMX2 DMX3 DMX 4 DMX 5 DMX 6 DMX 7 DMX 8
BT-NODE28