Adjusting The Cutting Line; Operating And Maintenance Instructions; General Operating And Maintenance Instructions; Lubricating The Flexible Drive Shaft - Solo 155 Instructions D'emploi

8.3 Adjusting the cutting line

When using a semi-automatic nylon head (Accessory
No.: 69 00 652 6):
Fig. 13
(schematic diagram)
Whilst the brushcutter is running without load, but with
rotating nylon head, lightly push the nylon head
several times onto ground with growth cover. The
cutting line will be dispensed in stages. With each
action, approx. 30 mm line will be dispensed. The line
trimming blade will correct any excess length.
When the cutting line is fully spent, you can replace it
with line available Ø 2,4 mm under part no. 6900942 or
Ø 3,0 mm part no. 6900974 (accessory).

9. Operating and maintenance instructions

9.1 General operating and maintenance
instructions
The maintenance and the repair of modern machines
as well as their safety-relevant assemblies require
qualified specialised training and a workshop equipped
with special tools and test equipment. Consequently
the manufacturer recommends that all tasks not
described in these operating instructions be carried out
by a specialised workshop. That specialist has the
required training, experience, and equipment at his
disposal, to provide you with the most cost-effective
solution for such work. He will provide additional help in
word and deed.
After a running-in time of app. 5 hours, all accessible
screws and nuts (except the carburettor adjusting
screws) must be checked for tightness and they must
be retightened, if required.
Check the cutter regularly and whenever you notice
any irregularities, or when the cutter/contact shield
becomes blocked. For this, switch off the engine and
wait until the cutter has come to a complete standstill.
Pull the spark plug cap, and remove grass, debris, etc.
from the cutter support. Immediately replace blunt or
damaged tools, even if they display only small cracks –
do a "ping" test.
Using your brushcutter ; Operating and maintenance instructions
It is best to store the equipment in a dry, safe location
with a full fuel tank. There should be no open flame or
similar nearby. For longer periods without using the
equipment (longer than four weeks), see chapter "9.9
Shutdown and storage".

9.2 Lubricating the flexible drive shaft

It is recommended to check the lubrication of the
flexible drive shaft before the start of each new job.
When required, but no later than after every 5 hours,
remove the flexible drive shaft from the flexible shaft
and replenish its lubrication.
Fig. 14
Pull the flexible shaft (12) off the engine flange (11)
after moving the locking lever (31) forward.
You can then remove the flexible drive shaft from the
flexible shaft (12).
Use commercially available general purpose grease,
that is temperature-resistant, to lubricate the shaft.
During the assembly, ensure that the flexible shaft fully
engages the engine flange.
ENGLISH 15