Basic Information Relevant To The Control Of Model Helicopters - Reely SKY Jet Ranger Notice D'emploi

The receiver/controller component (1) then carries out an
internal alignment that lasts for approx. 5 seconds. While
this is going on, the control LED (2) on the receiver/control-
ler component flashes red.
The helicopter must not be moved during this
time.
When the alignment is completed, both rotor control servo
motors run in neutral position (centre position) and the control
LED is lit red permanently.
Now your model is ready to start.
Attention!
If the control LED (see figure 6, item 2) flashes red during flight, you have to charge your model immediately
to prevent damaging deep discharging of the flight battery.
Caution, important!
Before starting to fly your model helicopter, you should take note of the following information first.
d) Basic Information Relevant to the Control of Model Helicopters
Before you fly your model, you should first familiarize yourself with the control possibilities open to you and thereby be
able to fly safely. The model helicopter is controlled via the two control sticks at the transmitter.
The following functions are available (see next pages).
Figure 6
39