Cooling Mode (Cool); Dehumidification Mode (Dry); Ventilation Mode (Fan); Heating Mode (Heat) (Only For Hp Models) - Olimpia splendid DOLCECLIMA BREZZA Serie Mode D'emploi Et D'entretien

3.5 - COOLING MODE (COOL)

a. Using this mode, the appliance dehumidifies and cools the environment.
This mode can be selected by pressing B7 or SW2 until when the cooling LED (S3a) is activated on the
control panel display.
b. The temperature set-point (Set temperature) can be adjusted from 16°C to 31°C with 1°C variations thanks
to B4/B5 or SW3/SW4 and the respective value appears on the display.
c. Three minutes (maximum) after the activation of this operating mode the compressor starts and the ap-
pliance starts to distribute cold air.

3.6 - DEHUMIDIFICATION MODE (DRY)

a. This mode can be selected by pressing B7 or SW2 until when the dehumidification LED (S4) is activated
on the control panel display.
b. In DRY mode, it is not possible to select the fan speed or to adjust temperature.
The fan motor works at low speed.
c. Keep doors and windows closed to achieve the best dehumidifying effect.
Do not place the air outlet pipe out of a window.
d. Connect the condensation discharge pipe (paragraph 2.5).

3.7 - VENTILATION MODE (FAN)

a. When this operating mode is used the appliance has no effect on the temperature or humidity of the
environment, it merely circulates the air.
b. This mode can be selected by pressing B7 or SW2 until when the ventilation LED
(S5) is activated on the control panel display.
c. In this operating mode, the internal fan is always on and it is possible to select the desired speed through
the keys B6 or SW6; the respective LEDs "High" (S0), "Medium" (S1) or "Low" (S2) light up.

3.8 - HEATING MODE (HEAT) (only for HP models)

a. The appliance heats the environment in this mode.
This mode can be selected by pressing B7 or SW2 until when the heating LED (S3b) activates on the
display of the control panel.
b. The temperature set-point (Set temperature) can be adjusted from 16°C to 31°C with 1°C variations thanks
to B4/B5 or SW3/SW4 and the respective value appears on the display.
c. After three minutes (maximum) from the activation of this operating mode, the compressor activates and
the appliance starts to supply heat.
d. Connect the condensation discharge pipe (paragraph 2.5).

3.9 - SLEEP MODE

• This function can be activated only from the remote control.
• This function is not available while the Dehumidification (DRY) and Fan Only (FAN) modes are
active.
a. This mode can be selected by pressing B3; the "Sleep mode" LED (S7) activates on the display of the
control panel.
The appliance will decrease (when cooling) or increase (when heating) the set temperature by 1°C (1 or
2 F) for 1 hour.
b. To stop the function, press key (B3) on the remote controller; the LED (S7) switches off.
EN - 22