Selecting A Location - Miller Phoenix 456 CC/CV Manuel Du Propriétaire

3-5. Selecting A Location

Movement
Location
18 in
(460 mm)
2
OR
1
5
18 in
(460 mm)
Tipping
Y Do not move or operate
unit where it could tip.
3
1
Use lifting forks to move unit.
Extend forks beyond opposite side
of unit.
2
Use handles to lift unit.
3
Use cart or similar device to move
unit.
4
4
Use rating label to determine input
power needs.
5
Locate unit near correct input
power supply.
Y Special installation may be
Lifting Forks
Lifting Handles
Hand Cart
Rating Label
Line Disconnect Device
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
loc_2 3/96 - ST-800 611 / ST-801 718
OM-188 422 Page 15