Publicité
Les langues disponibles
Les langues disponibles
Problems and solutions
The machine does not start
- Is the plug inserted into the socket?
- Is the socket not in good working order? Try another.
- Is the fuse burnt out? Replace it.
- Extension cable broken. Use another cable.
The pressure fluctuates
- The pump is sucking air in. Seal the connections correctly.
- Valves are dirty, worn or broken. Have them replaced.
- Pump seal work. Have it replaced.
- The nozzle is partially blocked. Clean it.
The machine stops
- Fuse burnt out. Replace it and switch other equipment off.
- Check that the socket has the correct Voltage.
- The thermal safety feature is activated. Allow it to cool and remove the cause of
the overheating.
- The nozzle is partially blocked. Clean it.
The fuse burns out
The electrical installation is too light. Connect the machine to an installation that
has greater Amperage than the machine. Do not use an extension cable.
The machine vibrates
- Air in the water supply hose. Allow it to escape by running water through the
machine while it is switched off.
- Problems with the water supply. Does it meet the requirements? Do not use an
excessively long or thin hose (min. ½").
- The nozzle is partially blocked. Clean it.
- Water inlet filter is dirty. Clean it
- There is a kink in the hose. Straighten it.
The machine regularly starts and stops by itself
Pump or spray lance are leaking. Have them repaired or replaced.
The machine starts but does not supply water
- Pump, hose or accessories are frozen. Allow them to thaw and then check them.
- No water supply. Ensure that there is a water supply.
- Filter blocked. Clean the filter.
- Nozzle blocked. Clean the nozzle.
Please contact your dealer if there are any other problems!
42
Publicité
