Publicité
Les langues disponibles
Les langues disponibles
Safety features
The nozzle is fitted with a 'lock' for safety. With the handle open, the pistol is
locked and will not function. Unlock the
pistol by pushing this handle back to the
original position (see fig. 8).
The motor is fitted with a thermal safety
feature
that
overheats. In principle, it will start again
automatically when it is sufficiently cooled.
But it is better to switch the machine off for
5 to 10 minutes, wait, and then start it
again. Identify the cause of the overheating
and remove it. If this problem recurs, stop
using the machine and contact your supplier / repair service.
Maintenance
Attention: Always take the plug out of the socket before you execute
maintenance!
Flush the water supply hose, the high-pressure hose, the jet lance, the nozzle
and other accessories thoroughly before you use them.
Carefully remove dust, sand or other dirt from the connections.
Thoroughly rinse and clean the accessories that you have used for spraying.
Regularly clean the nozzle with the pin
supplied and then flush it thoroughly
(against the direction of the jet). To do
this you must remove the nozzle from
the lance.
Regularly clean the filter in the water
inlet. To do this, unscrew the water inlet
connector, remove the filter with a little
pincers or similar tool and check that it is
undamaged. Fasten everything firmly and correctly in the appropriate place.
Never use the cleaner without a filter!
Keep the ventilation openings of the machine clean in order to prevent
obstruction of the cooling function.
Regularly grease the O-rings of the connectors in order to prevent them from
drying out.
Repairs and inspections must only be carried out by your supplier or
appropriately trained and authorised persons. Inexpertly executed repairs will
nullify the guarantee.
switches
it
off
Never carry out repairs yourself!
when
it
41
Publicité
