Volvo Penta 3863124 Instructions De Montage page 6

ENG
6. Push the grommet into the hole until it seats.
Caution!
Do not route trim/tilt sender leads under exten-
sion tube or hydraulic lines. Leads must be free
to move when drive unit steers, otherwise
sender or wire will be damaged.
7. Attach the retaining clip to the grommet inside
the transom plate.
8. Install the BROWN/BLACK wire in the "A"
terminal, the WHITE wire in the "B" terminal
and SOLID BLACK wire in the "C" terminal on
the Amphenal connector. Use Socket
Installer, Volvo Penta P/N 3854349, to push
the wire sockets into the rubber plug until
they seat.
Note! The use of alcohol will make socket
installation into the rubber plug easier.
6
TRIM SENDER ADJUSTMENT
34510
9. Connect an ohm meter to the sending unit
connector. Turn the sending unit control nut
until the meter reads 11 ± 1 ohm.
10. With lower edge of pivot housing pushed in
towards the gimbal housing, insert sending
unit control nut into pivot bolt head. Install two
trim sender mounting screws finger tight.
34467
42585
11. With the pivot housing pushed in towards the
gimbal housing, check adjustment of sending
unit between pins "A" and "C" of the sending
unit connector.
12. Rotate sending unit to obtain a 11 ± 1 ohm
reading on the meter, then tighten mounting
screws to 18-24 in. lb. (2,0-2,7 N•m).
19766A
19513A
42584
19514