AL-KO 161VB-2 Mode D'emploi Original page 12

en
ADVICE
Replacement parts are safety parts!
For the installation of replacement parts
into our products, we recommend the
use of original AL-KO parts, or of parts
that we have expressly approved for in-
stallation. For the clear identification of
replacement parts, our service stations
require the replacement part identifica-
tion number (ETI).
TROUBLESHOOTING
Malfunction
Inadequate braking effect
Reversing is difficult or blo-
cked
Driving is not smooth, or
braking is jerky
Inadequate handbrake effect Brake system set too tightly
Height adjustment of over-
run hitch is stiff
Little or no weight balancing
ADVICE
If you encounter any malfunctions that are not listed in this table or which you cannot rectify
yourself, please contact our appropriate customer service.
12
Type plate
2
1
Possible cause
Excessive abrasion losses
on the overrun hitch
Corrosion on the pull rod
Pull rod slides in completely
Serious damage when ma-
noeuvring
Brake system set too tightly
Shock absorber is defective
Drawbar joints have sei-
zed
Adjusting aid has seized
Gas spring too weak or de-
fective
1 ETI number
2 Drawing number
Solution
Remove dirt and corrosion from the
transmission device and brake cable,
and then check for ease of movement.
Check the brake adjustment
Contact an AL-KO service centre
Have the brake system adjusted
Have the shock absorber renewed
Have the brake system adjusted
Loosen, clean, and lubricate the joints
Have the gas spring replaced
1 651 934_c