Struers Discotom-5 Manuel D'instructions page 11

Front Panel Controls
Name Key
MAIN
SWITCH
Power
POWER
INDICATOR
s
START
o
STOP
Auto
AUTO
Auto
AUTO
INDICATOR
Discotom-5
Instruction Manual
Function
The main power switch is
located on the right hand
side of Discotom-5. Turn
clockwise to switch on the
power.
Lights when main power is
switched on.
Starts the machine. The cut-
off wheel starts rotating and
the cooling water is turned
on.
Stops the machine. The cut-
off wheel stops rotating and
the cooling water is turned
off.
Select or deselect automatic
cutting mode
Lights when automatic
cutting mode selected.
Name Key
v
FORWARDS
V
BACKWARDS
FEED SPEED
FEED SPEED
REDUCED
1
LOAD BAR
Reflects the present motor load status.
2
EMERGENCY
STOP
3
o
EMERG. STOP
OVERLOAD
Function
Moves cutting table forward.
Moves cutting table
backwards.
Regulates the feed speed of
the cutting table. The speed
can be set from 0.1-2.5
mm/sec.
Lights when the feed speed
has been set too high and is
reduced by the machine.
Push the red button to stop.
Pull the red button to release.
Lights when emergency stop
has been pressed or the
cutting motor is overloaded.
7