Adjusting The Hydraulic Rebound Damper; Tensioning The Chain - Beta RR 400 Mode D'emploi

ADJUSTING THE HYDRAULIC REBOUND
DAMPER
Turn screw G to adjust the hydraulic re-
bound damper.
Turning the screw anticlockwise (out) de-
creases the damping effect.
Standard adjustment RR 4t:
25 clicks from the completely closed position
Standard adjustment RR 4t Racing:
25 clicks from the completely closed position

TENSIONING THE CHAIN

To ensure the drive chain a longer life, it is
advisable to periodically check its tension.
Always maintain the chain clean and lu-
bricated.
If the chain play exceeds 30÷35 mm, ten-
sion the chain by following these steps:
•Loosen wheel spindle nut 1.
•Loosen counternuts A on either side of
the fork.
•Turn adjusting screws B on either side until
the desired chain tension is obtained.
•Tighten counternuts A on either side of
the fork.
•Tighten nut 1.
30 ÷ 35 mm
A
B
1
67
4
G
A
B
GB