Cutting Multiple Openings And Title Boxes - KEENCUT ULTIMAT GOLD Manuel D'instructions

6.4
You will
need
Pencil 3mm
Start of Cut Limit Stop
English

CUTTING MULTIPLE OPENINGS AND TITLE BOXES

The Start of Cut (green) Limit Stop can be used to great advantage after just a little practice to accurately cut
multiple openings beyond the normal scope of the Stops.
Pencil mark the back of the Mat Board with the required layout and place an
of the aperture to be cut is under or to the right of the cutter bar then the bevel will not be accidentally cut in the
wrong direction.
Place the Mat Board under the Cutterbar so the bevel blade cuts along the pencil line.
Set the Start of Cut (green) Limit Stop to zero.
Depress the Start of Cut Finger and move the Cutter Head until the tip of the finger reaches the horizontal line at
the beginning of a marked aperture.
Insert the bevel blade fully.
Release the Start of Cut Finger.
Cut until the depressed tip of the Start of Cut Finger reaches the horizontal line at the end of the marked aperture.
Repeat until all the apertures are complete.
Cutting Multiple openings & Title boxes
¹
Cutterbar
Start of Cut Finger
Cutter Head
KEY: Start of Cut Limit Stop
X
in each aperature to be cut. If the
¹ Cutterbar
Cutter Head
6.4
X