Table des Matières
Publicité
4.6
End of Cut (overcut), Schnittende
Final de corte, Fin de coupe,
Fine del taglio
English
START OF CUT
OVERCUT
Move the start of cut cur-
sor (green) the amount
measured by turning the
adjustment screw in the
©
direction to reduce
-
the cut.
Reset the start of cut (green) and end of cut (red) limit stops to 3 (cms/inches)
All the Stops have now been adjusted and set to cut an accurate mat for the thickness of matboard you have
selected. The Matguide Limit Stop should not go out of adjustment when cutting different types and thickness
of matboard, therefore, stage 1 of the adjusting procedure should not normally be needed. Just a check from time
to time is all that is necessary. As a general rule with all the cursors:-
Turn the adjusting screw.
©
In the
+
direction to increase the length of the cut
©
In the
direction to decrease th length of the cut.
-
KEY:
Operation
Adjusting the Limit Stops
End of Cut (undercut)
Schnittende
Final de corte
Fin de coupe
Fine del taglio
UNDERCUT
Measure/Estimate the length of the undercut/overcut
Move the start of cut cur-
sor (green) the amount
measured by turning the
adjustment screw in the
©
+
direction to extend
the cut.
in the normal way.
Start of Cut Limit Stop
START OF CUT
SCHNITTANFANG
DEBUT DE COUPE
INIZIO DEL TAGLIO
INICIO DE CORTE
END OF CUT
OVERCUT
Move the end of cut cursor
(red) the amount measured
by turning the adjustment
screw in the
©
direction to reduce
-
the cut.
End of Cut Limit Stop
4.6
END OF CUT
SCHNITTENDE
FIN DE COUPE
FINE DEL TAGLIO
FINAL DE CORTE
UNDERCUT
Move the end of cut cursor
(red) the amount measured
by turning the adjustment
screw in the
©
+
direction to extend
the cut.
Matguide Limit Stop
Publicité
Table des Matières
