Table des Matières
Publicité
4.1
English
CUTTING BOARD TO SIZE using the vertical cutter, fitted with a trapezium shaped blade adjust the depth so the
tip of the blade JUST protrudes the board being cut. It is not necessary to use a slip mat when vertical cutting.
To enable the blade to be quickly set for the different thickness of materials such as paper, matboard and
foamcore no preset stop is fitted.
Fit the Measuring Arm and ensure it is positioned correctly. Remove the Matguide if necessary.
Set the Measuring Arm Limit Stop to the dimension required.
Place the matboard under the Cutterbar and position it so the bottom right corner is against the Stop.
Lower the Cutterbar. Slide the Cutter Head away from you past the top edge of the matboard.
Ensure the vertical lock is off, (by turning clockwise) depress the blade holder and pull the Cutter Head towards you.
Do not press on the handle.
The Vertical Blade Holder can be locked in either the cutting position or the rest position. Twist counter-clockwise to
lock, clockwise to unlock.
KEY:
Cutter Head
Operation
Cutting Board to Size
'X'
Vertical Blade Holder
'X'
µ Measuring Arm Limit Stop
4.1
¹ Cutterbar
Publicité
Table des Matières
