Table des Matières
Publicité
4.4
Operation
4.4
1
1
Bevel Cutting
(Y)
English
THE LIMIT STOPS (cont)
Move the Cutter Head beyond the far edge of the matboard. Depress the Start of Cut Finger (Y) with the thumb of
the left hand until it touches the surface of the slip Mat.
Pull the Cutter Head towards you until the Start of Cut Finger connects with the edge of the matboard and stops.
Hold the Start of Cut Finger down and fully insert the blade with firm downward pressure on the Bevel Blade Holder.
Release the Start of Cut Finger.
Make the cut by pulling the cutter head until it stops against the End of Cut Limit Stop.
DO NOT REST YOUR HAND ON THE HANDLE WHILST CUTTING AS IT WILL SPOIL THE RESULTS
Release the Bevel Blade Holder.
Make three more cuts in the same way after turning the matboard counter-clockwise each time.
To check if the cuts are accurate measure the border width on the white side of the matboard and look for
over/under cuts in all corners on the coloured side. If there are inaccuracies refer to "Adjusting the Limit Stops"
page (10 - 11).
KEY:
Bevel Blade Holder
Cutter Head
End of Cut Limit Stop
Publicité
Table des Matières
