Removing The Start Of Cut Rule - KEENCUT ULTIMAT GOLD Manuel D'instructions

5.3
English

REMOVING THE START OF CUT RULE

Loosen screw with 3mm hexagon wrench.
Set the Vertical Blade Holder in the down position and loosen the second screw.
Remove the rule from the end of the Cutter Head.
If the machine is to be used without the Start of Cut Rule for any reason adjust both screws inwards to ensure they
do not interfere with the Vertical Blade Holder.
Maintenance
Removing the Start of Cut Rule
KEY: Cutter Head Vertical Blade Holder
5.3
You will
need
3mm