Table des Matières
Publicité
3.3
Preparation
3.3
Additional Matguide fittings (fittings optional)
English
Matguide Lock
Used if the Machine is set on a sloping table top to prevent the Matguide sliding down the edge of the base through
vibration.
Fit the Lock between the edge of the base and the Matguide slideway, tighten the screw and fit the T-bar.
Unequal Margin guide stops
When cutting a large batch of unequal margin mounts (see 'Cutting unequal margins') the additional stops (a) and (b) can
be fitted to the Matguide Slideway as shown. When the stops are set in the appropriate positions the T-bar can be quickly
moved to either of the two required dimensions.
(a)
(b)
Publicité
Table des Matières
