How To Assemble Your Ultimat Gold - KEENCUT ULTIMAT GOLD Manuel D'instructions

3.1

How to Assemble your ULTIMAT GOLD

English
HOW TO ASSEMBLE YOUR ULTIMAT GOLD
THE RUBBER FEET are supplied with self adhesive on the back. Position them as shown on the underside of the
Base, not on the End Plate.
THE MEASURING ARM is used when cutting matboard to size (sizing) and can be removed when bevel cutting.
Hold the Measuring Arm at 45 degrees to the Base and forward of the End Plate.
Present the Measuring Arm into the slot in the edge of the Base.
Engage the Measuring Arm upwards into the Base slot and lower the Measuring Arm to horizontal.
Lift the right hand end of the Measuring Arm and slide it towards you.
Reverse the instructions to remove the Measuring Arm.
THE MATGUIDE T-Bar is used when bevel cutting and can be removed when sizing matboard.
Clip Matguide Slideway into the Base slot.
Check the Matguide Slideway is level with the base. The plastic screw and lock nut on the underside of the slideway
can be adjusted if necessary.
Slacken the wingbolt on the T-bar and slide it onto the Matguide Slideway, fasten the wingbolt.
To remove the Matguide when sizing matboard either slide the T-bar from the Matguide Slideway or unclip the
Matguide complete.
THE LIFT AND HOLD is used to raise and hold the Cutterbar above the base so you can have both hands free
when positioning the matboard ready for cutting or when adjusting the Matguide T-Bar.
Position the Lift and Hold and fit the screw into the threaded hole and tighten using the 4mm hexagon wrench.
KEY: Matguide Slideway
Preparation
Matguide T-Bar Base
¸ End Plate
Measuring Arm
3.1
Lift and Hold