6.4 Manual partial light output (P)
In the manual mode
M
and the strobe mode
adjusted to fit the shooting situation with the manual partial light output para-
meter (P). Settings in manual flash mode M range from P 1/1 (full light output)
to P 1/256, in intervals of 1/3.
Setting procedure:
M
F 8.0
• Press the
MZoom 35
LC display.
17 m
P1/1
+
Para
–
• Set the desired light output (1/1-1/256) with the
+
or
ately.
M
F 8.0
• Press the button
MZoom 35
6,1 m
P1/8
the normal view. If the button
+
Para
–
display will change back to the normal view after
about 5 seconds.
In strobe mode
, the maximum partial light output is automatically
adjusted to fit the flash parameters chosen.
In strobe mode
, reduction of the manual partial light output is only
possible in full intervals.
When the number of flashes (N) and the flash frequency (f) are reset, the
partial light output is not reset.
108
, the light output can also be
button until „P" appears on the
Para
–
buttons. The setting takes effect immedi-
to change the LC display back to
is not pressed, the
7 Special functions (Select menu)
Special functions are selected using the
camera model and flash mode set, various special functions are available. If
certain special functions are not supported by your camera, these functions may
not be displayed in the menu. Also see table 2 for more information.
7.1 Setting procedure for the special functions
• Press the
button repeatedly until „Select"
Sel
appears on the display.
• Use the
and
arrows to select the item of
your choice or special function from the menu. The
selected menu item will be highlighted against a dark
background.
The following special functions are available, depen-
ding on the mode and camera model:
TTL/TTL-HSS/A
M/M HSS
Beep
Beep
Remote
Remote
-
FB
Standby
Standby
ML
ML
KEYLOCK
KEYLOCK
ZoomExt
ZoomExt
ZoomSize
ZoomSize
m / ft
m / ft
(Select) button. Depending on the
Sel
Select
Beep
Mode
Para
Sel
-
Beep
Remote
-
Standby
ML
KEYLOCK
ZoomExt
ZoomSize
m / ft
Table 2