Installing The Pump And Connecting It To The Pipe - Speck pumpen BADU Jet PRIMAVERA Installation

1
2
3
a
b
5.3.1

Installing the pump and connecting it to the pipe

1. Fasten the pump horizontally on a vibration-absorbing base.
The pump can be damaged by unauthorised mechanical strains being
placed on the pump!

2. The pipe should be connected free of tension in compliance with
3. Ensure that any leaks cannot cause consequential damage. Install
4. Ground drain (has to exist)

12/2014 VG 766.2320.050
Dimensions
in cm
Shaft width min. 70 cm
Mount switchgear in dry
room and above the water
level
Lay and fasten the hose
for the air regulation and
pneumatic button above
the water level
Aeration and ventilation to avoid
condensation
Mount the pump on a base or
similar foundation
Take up pipe directly before the pump and connect it free of
tension.
VDMA standard sheet 24277. Use compensators if necessary.
suitable drainage if necessary.
Measure the size of the ground drain according to the following
criteria:
– Size of the swimming pool
– Circulation flow rate
Aeration and ventilation DN 150 (125)
3
a
DN 90
~24 ~50
Sufficiently dimensioned drain required
5 Installation
a
2
(min. 11)
b
25
~95
WG23.140.000-1
1
Earthing strap
Fig. 16
EN 75