Speck pumpen BADU Jet PRIMAVERA Installation page 69

9.
10. Lead the pneumatic hoses through the lower/outer openings of the
11. Slide one O-ring (37) onto each pneumatic button (38/1; 38/2).
12. Mount the cap for the volume (21/1) and air regulator (111) by
13. Connect or bond the jet pump (92) with the suction tube (105.1),
14. Connect the pump motor in accordance with the wiring diagram.
15. Switching on and off from the pool using the pneumatic buttons:
12/2014 VG 766.2320.050
Align the stainless-steel cover with the protruding centring nubs to
the existing recesses of the suction panel (93) and press them
together by hand. Observe the "UP" marking on the stainless-steel
cover. To fasten the cover use a screwdriver to bend the two
offset tabs towards the back (Fig. 11).
light cover (110) (light ON/OFF left; pump ON/OFF right). Align the
light cover (110) central to the nozzle housing (102.1) and fasten
with four tapping screws (112) (Fig. 12).
Only tighten the screws hand-tight. Do not use any force!
Fasten the pneumatic hoses to the corresponding buttons using
the hose clamps (46). Insert the two pneumatic buttons through
the light cover (110) in the nozzle housing and lock by turning it
clockwise (Fig. 12).
means of a rubber mallet and a protective cloth (Fig. 13).
adapter (97) and screwed connection (98; 99) and at the intake
side with the pressure tube (106.1) and special reducer (79) at the
delivery side (Fig. 14).
Ensure that the direction of rotation is correct for three-phase
current! Only carry out the direction of rotation check when
the pump is completely filled with water!
Pump ON/OFF (38/1) - right-hand button

Light ON/OFF (38/2) - left-hand button

Volume regulator from the pool with the rotary button (21/1):
OPEN - Left rotation

CLOSE - Right rotation

Air can optionally be added with the air regulator (111) from the
pool:
OPEN - Left rotation

CLOSE - Right rotation

5 Installation
EN 69