Alcove Framing; Remote Receiver Placement; Minimum Mantel Clearances - Napoleon BGD36CFNTR Instructions D'installation Et D'utilisation

6.6

ALCOVE FRAMING

NOTE: Recesses or alcoves above the appliance can be made as deep as desired provided the minimum
clearances to combustibles are maintained.
Non-combustible material can be used, provided the minimum clearances to combustible materials are applied.
The minimum enclosure volume must be increased by no less than the volume of the recess. This adjustment
can be made by increasing any or all of the height, width and depth of the enclosure.
6.8

REMOTE RECEIVER PLACEMENT

Position the remote receiver in the valve compartment close to the electrical junction box. Ensure the
receiver is on top of the placement label, if equipped.
6.7

MINIMUM MANTEL CLEARANCES

RISK OF FIRE, MAINTAIN ALL SPECIFIED AIR SPACE CLEARANCES TO COMBUSTIBLES. FAILURE
TO COMPLY WITH THESE INSTRUCTIONS MAY CAUSE A FIRE OR CAUSE THE APPLIANCE TO
OVERHEAT. ENSURE ALL CLEARANCES (I.E. BACK, SIDE, TOP, VENT, MANTEL, FRONT, ETC.) ARE
WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUST BE
RECESS OR
ALCOVE
AREA
FIREPLACE BASE
JUNCTION
BOX
PLACE REMOTE
RECEIVER ON TOP
OF THIS LABEL
!
CLEARLY MAINTAINED.
HEAT RESISTANT TO PREVENT DISCOLOURATION.
ENCLOSURE
AREA
APPLIANCE
WARNING
39
71.2
35.25
73.1
W415-1132 / C / 08.20.13
EN