Controlling The Vehicle - Reely 4WD RtR Notice D'emploi

j) Controlling the vehicle
Place the ready-to-drive vehicle on the ground. Do not reach into the engine or hold the wheels.
Do not make sudden adjustments to the remote control levers. Carefully operate the throttle/brake lever
and steering wheel on the transmitter until you have familiarised yourself with the responses of the vehicle.
If the vehicle shows a tendency to move to one side, adjust the steering trim on the remote control accordingly.
LED signals on the speed controller whilst driving
the vehicle
LED off
LED flashes; the LED flashing frequency corresponds
to the vehicle's speed
LED is steady on
The following images are for reference purposes only and do not necessarily correspond to the design of
the remote control/transmitter included with the product!
1. Release the throttle/brake lever (move it to the neutral position). The vehicle should roll to a halt or stay stationary
(if necessary, adjust the throttle trim on the remote control).
2. Slowly pull the throttle/brake lever towards the handle to make the vehicle move forwards.
3. Slowly push the throttle/brake lever away from the handle to make the vehicle move backwards.
Do not switch between the directions of movement immediately, but stop the vehicle first before moving in
the other direction. A direct change of the direction of movement can overload the gear.
44
Meaning
Throttle/brake lever on transmitter is in the neutral posi-
tion; the vehicle is stationary
Vehicle is moving forwards or backwards
Full throttle forwards