Controlling The Vehicle - Reely Bulldog Notice D'emploi

i) Controlling the Vehicle
Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive
too quickly at the beginning until you get used to the car's reactions. Do not make any quick and jerky
movements with the operating elements of the remote control.
If the vehicle tends to pull towards the left or the right, set the steering trim on the transmitter accordingly.
When switching between forward and reverse driving, the throttle/brake lever must be put in the neutral position (neu-
tral position = let go of lever, do not move it) briefly (approx. 1 - 2 seconds). If the throttle/brake lever is moved from
forward to reverse directly, the brake function of the drive is activated (vehicle will not reverse).
The following figures are only to illustrate the functions and do not necessarily correspond to the design of
the transmitter provided!
1. Release throttle/braking lever, vehicle rolls to a halt (or does not move, if required, correct trimming), lever is in
neutral position
2. Drive forwards, slowly pull the throttle/brake lever towards the handle
3. Drive forwards and then brake (vehicle slows down; it does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping
4. Drive forwards and then go into reverse (wait briefly between the change (approx. 1 - 2 seconds) and leave the
throttle/braking lever in its neutral position!)
Wait briefly
44