Operation; Removing The Chassis; Programming The Speed Controller; Inserting Batteries/Rechargeable Batteries Into The Remote Control - Reely 4WD RtR Notice D'emploi

9. Operation

a) Removing the chassis
Pull out the four safety clips on the top of the vehicle. Loosen the hook and loop fasteners on the left and right of the
vehicle body and carefully lift off the body.
Then release the connection between the vehicle and the LED bar on the top of the body.
b) Programming the speed controller
The speed controller offers various adjustment options, for example, you can select the type of rechargeable battery
used (NiMH or LiPo).
Important!
If you are using a LiPo vehicle battery and set the battery type to NiMH, the battery will overdischarge and
be permanently damaged. Always ensure that you select the correct battery type before driving the vehicle.
The speed controller is already pre-programmed in the default setting. After a reset, you must still check the
settings (especially for the rechargeable battery type) and change them if necessary.
For programming of the speed controller, refer to chapter 10.
c) Inserting batteries/rechargeable batteries into the remote control
Open the battery compartment on the remote control and insert new or fully charged batteries. Ensure that the
batteries are inserted in the correct polarity (observe the positive/+ and negative/- markings). Replace the battery
compartment cover.
Read the remote control instructions included with the product.
d) Configuring the remote control
Switch on the remote control and set the steering and throttle trim to the central position. If the remote control has a
dual rate feature, disable it or adjust it so that the steering angle is not limited.
Read the remote control instructions included with the product.
41