Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16 INSTALLATION INSTRUCTIONS
1
These instructions are an official document and an integral part of the trailer hitch. It
should be stored in a glove box all the time and handed over with the vehicle if sold.
17 REINSTALLATION OF COMPONENTS
1
Reinstall outside lower covers.
2
Reconnect RAB harness
Reinstall rear bumper fascia.
3
Note: attach fascia to hitch member brackets using 2 push-pins
4
Reinstall rear tail lamps. Remember to reconnect wiring harness.
5
Reinstall rear tail light covers.
6
Reinstall spare tire and related components.
7
Place ball mount "I", pin "K", and clip "J" in cargo area.
8
Replace rear compartment cover.
9
Place receiver plug "N" into tow hitch receiver neck.
18 CAUTION
1
For further information, read vehicle's owners manual or consult your dealer or dealer's
service department.
2
SUBARU accepts no liability for product defects caused by the vehicle owner or other
persons and/or incorrect use.
3
After the first 600 miles, please consult with SUBARU dealer to re-check the tightness
of Trailer Hitch bolts and/or nuts.
4
For models equipped with BSD (Blind Spot Detection) and RCTA (Rear Cross
Traffic Alert) driving support systems, when towing a trailer, press BSD/RCTA OFF
switch to deactivate the systems. The system may not operate properly due to the
blocked rader waves. For details about BSD/RCTA OFF switch, refer to the owners
manual "BSD/RCTA OFF switch".
5
For models equipped with RAB (Reverse Automatic Braking) system, please consult
with SUBARU dealer when towing a trailer.
PART NUMBER
ISSUE
L101SFL000
1
!
DATE
6/26/2017
SUBARU OF AMERICA
PAGE
18
18
OF
Publicité
Table des Matières
