Subaru L101SFL000 Instructions De Montage page 17

14 WIRING HARNESS INSTALLATION (CONT'D)
9 Locate the wiring harness pre-arranged connector at the LH side of the trunk.
10 Connect the tow hitch wiring harness to the vehicle side connector.
11 Route the wiring across the rear trunk panel as shown below.
12 Peel backing off the double sided tape on fuse holder and attach to the power
convertor (ECU). Peel the backing off the double sided tape of the ECU and attach in
the side of the spare tire area as shown. Make sure that the fuse is firmly pressed onto
the ECU and that the ECU is pressed firmly onto the flat inner wall of the spare tire
area. Be sure it will not interfere with the spare tire.
13 Wrap the pre-arranged-to-tow hitch connection with foam tape "Q". Wrap any
excess length with an 11" cable tie "O".
14 Install the 4-pin connector into the wiring harness mounting bracket on the tow hitch
using the clamp bracket and hardware included in the wiring harness kit "K". Tighten
the bolts to 5±1 in-lb.
PART NUMBER ISSUE
L101SFL000 1
11
DATE
6/26/2017
10
12
SUBARU OF AMERICA
9
13
PAGE
15
OF
18