Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2 REMOVE REAR BUMPER FASCIA
1
With a screwdriver, release (1) small push pin fastener per side on the LH/RH fascia
wheel well. Use the tip of the screwdriver to push the center of the pin.
2
With a small flat head screwdriver, remove (8) large push pin fasteners across the
length of the bumper. Save push pins for later use.
3
Starting at the LH side wheel well, using both hands, pull one side of the fascia out
from the vehicle.
4
Continue around the rear LH side. At the rear corner, begin to pull rearward and work
across the vehicle from left to right to remove the entire bumper.
5
Disconnect the RAB sensor harness.
6
Fully release the bumper from the vehicle body.
7
Lay fascia aside where it will not be damaged during hitch installation.
2
(x8)
4
PART NUMBER
ISSUE
L101SFL000
1
3
4
DATE
6/26/2017
SUBARU OF AMERICA
1
(TOP OF
VEHICLE)
(TOP OF
VEHICLE)
clip remover
PAGE
5
18
OF
Publicité
Table des Matières
